Section IX. TIRES, TUBES AND WHEELS
3-39. General
The rotary compressor is equipped with two
pneumatic tube-type tires mounted on 3/4 inch
diameter spindles. The wheels are equipped
with ball bearings which are lubricated through
grease fittings located on the inner wheel half.
3-40. Wheel Assembly
a. Removal.
(1) Remove wheel from axle spindle as
shown in figure 3-11.
(2) Disassemble wheel as illustrated in
b. Cleaning and Inspection.
solvent. Inspect parts for cracks, cor-
rosion, and other damage.
(1) Clean inner and outer wheel halves,
(2) Clean tires and inspect for cracks,
bearings and hardware in an approved
