TM 5-4310-276-14
the handtruck.
lockwashers (3), and capscrews (4). Lift engine from
Figure 4-18. Engine, brackets, and drive pulley, removal and installation.
with lockwashers (6) and capscrews (5),
and engine mounting
(4) Place engine in position on handtruck and
(7) Remove pully (8), key (9), capscrews (10)
and bushing (11).
washers (2) and nuts (1).
(8) Pack the starting rope and the fuel filter
in a waterproof protective bag and attach to the en-
(3), fuel line (2) and nut (1). Care should be exer-
gine.
cised when mounting to ensure that threads are not
b. Installation
crossed and that the fittings are tight and do not
(1) Detach the bag containing the starting
leak. Use the recommended pipe seal or compound
rope and the fuel filter from the replacement en-
to seal the threads and fittings.
gine.
(6) Loosen the four engine mounting bolts and
install the V-belts. Adjust belt tension to obtain
pulley (8) with capscrews (10). Attach pulley and
belt deflection of 3/4 of 1 inch midway between pul-
key (9) to engine shaft.
leys. Tighten engine mounting bolts.
(3) Attach mounting brackets (7) to engine