TM 5-4310-276-14
DIRECT
AND
GENERAL
SUPPORT
MAINTENANCE
INSTRUCTIONS
S e c t i o n I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
and TM 5-2805-256-24P (Engine),
Special Tools and Equipment
The special tools required to perform direct and
general support maintenance on the compressor are 5-3.
Fabricated Tools and Equip-
listed in table 5-1.
ment
No specially fabricated tools and equipment are
required by direct and general support maintenance
5-2.
Repair Parts
p e r s o n n e l to perform maintenance on the
Repair parts are listed and illustrated in the re-
pair parts and special tools list TM 5-4310-276-24P,
Use
Item
NSN
Inlet valve retainer removal and installation. Also re-
5120-00-357-7692
Wrench, Inlet Valve Retainer
moval and replacement of valves and springs.
Outlet valve retainer removal and istallation. Also re-
5120-00-357-7691
Wrench, Outlet Valve Retainer
moval and replacement of valves and springs.
Outlet valve seat removal and installation. Also re-
5120-00-357-7721
Wrench, Outlet Valve Seat
moval and replacement of valves and springs.
Inlet valve seat removal and installation. Also removal
5120-00-357-7722
Wrench, Inlet Valve Seat
and replacement of valves and springs.
TROUBLESHOOTING
Section II.
may occur, nor all tests or inspections and cor-
General
rective actions. If a malfunction is not listed or is
a. This section contains troubleshooting infor-
not corrected by listed corrective actions, notify
mation for locating and correcting most of the oper-
your supervisor.
ating troubles which may develop in the com-
pressor. Each malfunction for an individual
component, unit, or system is followed by a list of
Direct and General Support
tests or inspections which will help you to deter-
M a i n t e n a n c e Troubleshooting
mine corrective actions to take. You should perform
the tests/inspections and corrective actions in the
mation.
order listed.
NOTE
b. This manual cannot list all malfunctions that
Before you use this table, be sure you have per-
formed all applicable operating checks.
