TM 5-4310-276-14
(1) Clean the oil pan with drycleaning solvent,
(2) Remove four screws and remove the oil
item 5, App. D.
pan cover.
(2) Remove all sludge and carbon deposits;
(3) Remove eight screws and remove oil pan.
dry thoroughly.
(4) Remove and discard oil pan gasket.
(3) Inspect oil pan for cracks, breaks, war-
b. Cleaning and Inspection.
page, bent or broken cooling fins, stripped or dam-
aged threads or evidence of leakage.
(4) Inspect drain plugs and threads for burrs,
damaged threads, and magnetic capabilities.
Drycleaning solvent, P-D-680, used to
(5) Repair or replace oil pan if damaged or de-
clean parts is potentially dangerous to
fective.
personnel and property. Avoid re-
c. Installation.
peated and prolonged skin contact.
(1) Install new oil pan gasket.
Do not use near open flame or exces-
sive heat.
to 25 to 30 inch-pounds.
(3) Install oil pan cover.
(4) Install oil drain plugs and refill oil pan.
Section II. ENGINE SPEED GOVERNOR AND CONTROL
6 - 4 . Governor and Control.
6-3. General
a. Removal.
A centrifugal flyweight-type governor controls
the engine speed. This governor is directly gear
retor and throttle controls.
driven by the engine camshaft. The ignition system
(2) Tag and disconnect low tension cable (fig.
breaker points, condensers, and radio suppression
6-2 or fig. 6-3).
filters of the ignition system are housed in the outer
section of the governor housing.
