TM 5-4310-277-14
d. Assembly.
c. Cleaning, Inspection and Repair.
(1) Install the side plates (13, fig. 6-8) on the
base (14).
Dry cleaning solvent, P-D-680, used to clean
(2) Install the strap (12) and secure with washer
parts is potentially dangerous to personnel
(11), screw (10), washer (9), and nut (8).
and property. Avoid repeated and
(3) Install the identification plate (7) and secure
prolonged skin contact. Do not use near
with drive screws (6).
open flame or excessive heat. Flash point of
(4) Install plates (4 and 5) and secure with
solvent is 100 F. (38C. ) - 138 F. (59 C.).
screws (3), washers (2), and nuts (1).
(1) Clean items with cleaning solvent, Federal
e. Installation.
Specification P-D-680, and dry thoroughly.
(2) Inspect frame for cracks, breaks, and
(1) Install air receiver, paragraph 4-37.
(2) Install engine, paragraph 4-39.
broken welds.
(3) Weld breaks or replace the base assembly.
(3) Install compressor, pagagraph 4-21.
