TM 5-4310-277-25P
INTRODUCTION
1. Scope
The following provides an explanation of col-
This manual lists repair parts and special
umns in the tabular lists in sections II through
tools required for the performance of organi-
VI.
zational, direct support, general support, and
a. Source, Mainteenance, and Recoverability
depot maintenance of the compressor.
Codes (SMR).
Note. Common hardware items known to be readily
2. General
available in Army supply channels will be assigned
Maintenance codes only. Source codes, Recoverability
a. The repair parts list is arranged as fol-
codes, and Maintenance Allowance will not be assigned
lows:
to this category.
( 1 ) Individual parts and major assem-
(1) Source Code. Indicates the selection
blies are listed alphabetically by item name
status and source for the listed item. Source
within the numbered functional groups.
codes used are:
(2) Assembly components and subassem-
Explanation
blies are indented and listed alphabetically by
P
Applied to repair parts which are stocked
item name under major assemblies.
in or supplied from DSA/GSA or Army
supply system, and authorized for use at
b. This Repair Parts and Special Tools List
indicated categories.
is divided into the followng sections:
Applied to repair parts which are not pro-
M
cured or stocked but are to be manufac-
(1) Prescribed Load Allowaance (PLA)-
tured at indicated maintenance categories.
S e c t i o n II. A consolidated listing of repair
A
Applied to assemblies which are not pro-
parts (quantitatively allocated for initial stock-
cured or stocked as such but made up of
age at the organizational level. This is a man-
two or more units, each of which carry
datory minimum stockage allowance.
individual stock numbers and descriptions
and are procured and stocked and can be
( 2 ) Repair Parts-Section III. A list of
assembled by units at indicated mainte-
repair parts authorized for the performance
nance categories.
of maintenance at the organizational level.
X
Applied to parts and assemblies which are
not procured or strocked, the mortality of
( 3 ) Specal Tools, T e s t a n d S u p p o r t
which is normally below that of the appli-
EquipmentSection IV. Not Applicable.
cable end item, and the failure of which
(4) Repair Parts-Section V. A list of
should result in retirement of the end item
repair parts authorized for the performance
from the supply system.
of maintenance at the direct support, general
X1
Applied to repair parts which are not pro-
cured or stocked, the requirement for
support, and depot level.
which will be supplied by use of the next
(5) Special Tools, T e s t a n d S u p p o r t
higher assembly or components.
Equipment--Section VI. Not Applicable.
X2
Applied to repair parts which are not
(6) Federal Stock Number and Reference
stocked. The indicated maintenance cate-
Number Index-Section VII. A list of Federal
gory requiring such repair parts will at-
tempt to obtain them through cannibali-
stock numbers followed by reference numbers,
zation; if not obtainable through canni-
appearing in all the listings, in ascending al-
balization, such repair parts will be requi-
phanumeric sequence cross-referenced to index
sitioned with supporting justification
number.
through normal supply channels.
