SECTION IX
ELECTRICAL ACCESSORIES AND COMPONENTS
3. Cleaning, Inspection and Repair.
A. GENERAI,
a. Clean all parts with an approved cleaning solvent
The electrical accessories consist of the magnetic
and dry thoroughly.
starter with pressure switch and strip heater with
b. Replace all defective or worn parts.
thermostat for air filter. Air pressure from the air
4. Reassembly. Refer to figure 12 and reassemble
receiver tank against the diaphragm of the pressure
magnetic starter components.
switch energizes thc starter switch causing the
5. Installation. Install the magnetic starter as illustrated
contacts to close The strip heater and thermostat
are mounted on the air filter.
C. STRIP HEATER AND THERMOSTAT
B. MAGNETIC STARTER WITH PRESSURE SWITCH
1. Removal. Remove strip heater and thermostat as
1. Removal.
Re-move the magnetic starter as
defective parts,
2. Disassembly.
as necessary.
magnetic starter components as instructed.
2. Installation. Install strip heater and thermostat as
Figure 12. Magnetic starter with pressure switch, removal and installation (shown with cover removed)
SECTION X
RELATED COMPONETS
A. GENERAL
B. AIR FILTER ASSEMBLY
The air compressor assembly is a two-cylinder, two
1. Removal.
a. Remove the strip heater and thermostat as
stage, air cooled unit. It consists of air intake muffler,
instructed in C above.
intercooler and aftercooler tubes, manifolds and high and
b. Remove the air filter as instructed on figure 13.
low pressure cylinders. The air filter, dehydrator and
regulator monitor the air pressure from the air receiver
tank.
13