TM 5-4310-352-14
brace(9) and remove clamp (8) from aftercooler tube (10)
valve from frame cover.
(8) Loosen fittings on each end of the after-
(2) Unscrew inlet air filter (fig. 2-1, sheet 3)
cooler. tube from elbows (11) and remove aftercooler
from the close nipple.
tube and elbows.
(3) Drain oil from the frame (LO 5-4310-2-12).
(9) Loosen fittings on each end of the inter-
(4) Remove frame end cover by removing six
cooler tube (12) from elbows (15 and 16).
capscrews (9, fig. 4-3).
(10) Remove safety valve (13) from elbow (14)
(5) Remove centrifugal unloaded (20 thru 27,
and remove elbow (14) from elbow (15).
(11) Remove elbow (15 and 16) from compres-
(6) Remove nut (2, fig. 6-5), lockwashers (3),
sor.
capscrew (4) from fanwheel (5) and remove fanwheel.
(7) Remove capscrew (6), lockwasher (7) from
Figure 6-5. Fanwheel, aftercooler, and intercooler removal.
(12) Remove tube connector (28, fig. 6-6).
(17) Remove four nuts (10), lockwashers (11)
(13) Remove capscrew (14) and washer (15)
from screw (12) and remove screw and valves (13) from
from complete cylinder (16) and remove cylinder and
spacer (8).
gasket (18) from compressor frame (17, fig. 6-8).
(18) Remove gasket (9) from top of cylinder.
(14) Remove capscrew (1, fig. 6-6) from com-
(19) Remove rings (24, 25 and 26) from piston
plete air head (2).
(28})
(15) Remove air head (3) and gasket (4) from
(20) Remove lockrings (21), pin (22) and con-
cylinder (17).
necting rod (27) from piston (23).
(16) Remove spacer (8) from cylinder.
6-6
