TM 5-4310-368-14
(3)
Remove bushing, drive sheave and shaft key from output shaft.
(4)
Drain oil from clutch housing.
(5)
Push clutch operating lever in to disengage clutch.
(6)
Remove four bolts, lock washers, inspection cover and gasket.
(7)
Use a drift pin and hammer to drive out two roll pins.
(8)
Remove pinch bolt from clutch operating lever. Remove lever from clutch yoke shaft.
(9)
Slide yoke shaft out of clutch housing. Lift clutch yoke out of clutch housing.
(10) Loosen and remove four nuts and lock washers. Remove clutch housing and gasket.
(11) Remove setscrew and lock washer.
(12) Loosen and remove pinch bolt, lock washers and nut.
(13) Remove clutch assembly and shaft key from engine crankshaft.
d.
Disassembly
(1)
Remove snap ring from PTO shaft.
(2)
Use brass mallet and drive PTO shaft out of shaft bearing.
(3)
Remove second snap ring, bearing retainer and bearing.
(4)
Loosen and remove bolt, lock washer and adjustment lock.
(5)
Loosen and remove two bolts and nuts from release collar. Remove collar.
(6)
Unscrew and remove adjusting ring.
(7)
Remove clutch pressure plate assembly, driven member and bearing from clutch housing.
e.
Cleaning and Inspection
(1)
Clean all parts in cleaning solvent. Dry thoroughly.
(2)
Inspect all threaded parts and tapped holes for damaged threads. Repair or replace defective parts.
(3)
Inspect wear members for damage or excessive wear. Replace defective parts.
f.
Reassembly
(1)
Install bearing into clutch housing.
(2)
Install three return springs into clutch housing.
4-37
