TM 5-4310-368-14
(3)
Carefully lower intake and exhaust manifold assembly over studs. Seat manifold onto seals.
(4)
Install four nuts and four washers. Tighten to 18 Ib-ft torque.
(5)
Install carburetor. Refer to direct support maintenance.
(6)
Connect exhaust pipe to exhaust manifold elbow.
(7)
Install seal clamp.
(8)
Install and secure two bolts, two nuts and four washers.
(9)
Start engine and check for leaks.
(10) Stop engine.
(11) Repair any leaks.
4-32.
CRANKCASE BREATHER
This task covers:
a.
Inspection
b.
Removal
c.
Installation
INITIAL SETUP
Applicable Configurations
All
a.
Inspection. Inspect crankcase breather for cracks, leaks or damage. Replace defective breather.
b.
Removal
(1)
Hold base of crankcase breather tube with a pair of vice grip type pliers.
4-32
