TM 5-4310-368-14
CHAPTER 5
DIRECT SUPPORT MAINTENANCE
Section I. GENERAL
5-1.
SCOPE
This section covers maintenance procedures to be used by direct support maintenance personnel. It also covers
instructions for removal and installation of major components such as engine, compressor, axle, and so forth.
Section II. REMOVAL OF MAJOR COMPONENTS
5-2.
ENGINE ASSEMBLY
a. Removal
(1)
Remove enclosure roof. (Figure 5-1)
(2)
Drain engine oil. (Figure 5-2)
(3)
Disconnect fuel line at fuel pump. (Figure 5-3)
(4)
Disconnect starter cable and ground cable. (Figure 5-4)
(5)
Disconnect main wire harness at throttle solenoid, magneto and oil pressure switch.
(6)
Remove four engine mounting bolts and nuts.
(7)
Remove drive belts for compressor and alternator. (Figure 5-5)
(8)
Disconnect clutch linkage at clutch.
(9)
Attach lifting device beneath exhaust manifold.
(10)
Disconnect oil drain line at engine.
(11)
Disconnect air cleaner tube at carburetor. (Figure 5-6)
(12)
Remove engine from frame.
5-1
