TM 5-4310-368-14
(6)
Install two brake links. Secure with two cotter pins.
(7)
Align bolts in brake lever with holes in frame. Secure to frame with two nuts and two lock washers.
4-57.
WHEEL HUB AND BRAKE DRUM, WHEEL BEARINGS AND SEALS
This task covers:
a. Removal
c.
Repair
b. Cleaning and Inspection
d. Installation
INITIAL SETUP
Applicable Configurations
All
Equipment Condition
Paragraph
Condition Description
Wheel and Tire Removed
General Safety Precautions
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially
dangerous to personnel and property. Avoid repeated and prolonged
skin contact. Do not use near open flame or excessive heat. Flash
point of solvent is 100 (38 ) - 138 (59 ).
F
C
F
C
a. Removal
(1)
Remove tire and wheel assembly (paragraph 4-55).
(2)
Remove hub cap.
(3)
Remove cotter pin.
(4)
Remove wheel bearing nut and washer.
(5)
Remove wheel hub from axle.
(6)
Remove seal from inside of hub.
(7)
Remove inner and outer wheel bearings.
(8)
Drive inner and outer bearing races out of wheel hub.
4-58
