TM 5-4310-368-14
b. Installation
(1)
Turn belt tensioner screw counterclockwise until engine base plate is at full travel toward compressor.
(2)
Lift engine onto base plate. Align holes in engine, base plate and frame. Loose assemble four bolts and
nuts.
(3)
Attach and secure starter cable and ground cable. (Figure 5-4)
(4)
Attach and secure fuel line at fuel pump. (Figure 5-3)
(5)
Attach and secure main wire harness at throttle solenoid, magneto and oil pressure switch.
(6)
Install drive belts for compressor and alternator. Refer to organizational maintenance for belt adjustment.
(7)
Attach clutch linkage at clutch. Secure with cotter pin.
(8)
Attach and secure oil drain line at engine.
(9)
Fill with proper oil. (Figure 5-7)
(10) Install roof panel. (Figure 5-1)
(11) Connect air cleaner at carburetor. (Figure 5-6)
(12) Start engine and check for leaks and proper operation of clutch and throttle.
(13) Stop engine.
5-3.
COMPRESSOR ASSEMBLY
a. Removal
(1)
Drain compressor oil. (Figure 5-8)
(2)
Remove enclosure roof. (Figure 5-9)
(3)
Remove side access panel. (Figure 5-9)
(4)
Disconnect air cleaner at compressor.
(5)
Remove drive belts. (Figure 5-10)
(6)
Disconnect oil drain hose at compressor.
(7)
Remove four nuts and washers.
(8)
Disconnect all gage tubing at compressor.
(9)
Disconnect air line at aftercooler.
5-4
