TM 5-4310-368-14
(10)
Disconnect condensate drain tubes.
(11)
Disconnect main wiring at two solenoid valves.
(12)
Attach lifting device and remove compressor. (Figure 5-11)
b. Installation
(1)
Attach lifting device and lift compressor over frame. (Figure 5-11)
(2)
Align four bolts holes in base of compressor with four studs in frame. Lower compressor over studs onto
frame.
(3)
Loose assemble four washers and four nuts onto four studs.
(4)
Use a straight edge and align face of compressor flywheel with engine drive sheave. Tighten four nuts.
(5)
Attach engine oil drain line at compressor.
(6)
Fill compressor with proper oil. (Figure 5-13)
(7)
Install and secure three condensate drain tubes.
(8)
Connect and secure all gage tubing at compressor.
(9)
Connect air tube at aftercooler.
(10)
Install and tighten drive belts. (Figure 5-10)
(11)
Connect air cleaner at compressor.
(12)
Start engine and compressor. Carefully check for leaks. Repair all leaks.
(13)
Stop engine and compressor.
(14)
Install enclosure roof. (Figure 5-9)
(15)
Install side access panel. (Figure 5-9)
5-4.
AXLE ASSEMBLY
a. Removal
(1)
Raise compressor off of ground. Support with blocks or jack stands.
(2)
Disconnect brake rods at axle. (Figure 5-14)
(3)
Remove four bolts and washers. (Figure 5-14)
(4)
Remove axle. (Figure 5-14)
5-7
