TM 5-4310-373-14
This task covers:
The removal of the centrifugal unloader assembly.
INITIAL SETUP
Equipment Condition:
Tools:
Compressor unit OFF
Main power OFF
Materials/Parts:
As required
Personnel Required:
Approximate Time Required (minutes):
1 Mechanic
30
LOCATION/lTEM
REMARKS
ACTION
Disconnect.
1. Main power
Remove.
See para 4-34.
2. Breather tube and
fittings
Remove.
3. Unloader tube and
See para 4-34.
fittings
4. Screws (1)
See Figure 4-66.
Remove.
Remove.
5. Cover (2)
Remove and discard.
Used gaskets do not seal properly.
6. Gasket (3)
7. Plunger (4)
Remove.
WARNING
You must use safety glasses
when using a hammer. A chip
from the hammer could strike
an eye.
Drive out using drift punch
8. Pin (5)
and hammer.
9. Weights (6)
Remove.
Remove.
10. SIeeve (7)
Remove.
11. Spring (8)
12. Washer, flat (9)
Remove.
4-56
