TM 5-4310-375-14
Figure 3-5. Air intake filter inspection, service, or replacement.
Legend for fig 3-5: Continued
SERVICE:
STEP 1.
REFER TO INSPECTION STEP 1 ABOVE. WIPE COVER AND BASE CLEAN WITH A CLEAN, LINT-FREE,
CLOTH DAMPENED WITH A SOLUTION OF HOUSEHOLD TYPE, LOW-SUDSING, DETERGENT AND
WARM WATER. RINSE AND DRY.
STEP 2.
CLEAN ELEMENT BY IMMERSING IN THIS SOLUTION OF DETERGENT AND WATER. AGITATE AND
SOAK TO REMOVE ACCUMULATED DUST AND DIRT. SHAKE OFF EXCESS SOLUTION.
RINSE ELEMENT IN CLEAN WATER TO REMOVE ALL DETERGENT SOLUTION AND AIR DRY.
STEP 3.
STEP 4.
ASSEMBLE CLEAN ELEMENT, COVER, AND SECURE WITH WING NUT.
REPLACEMENT:
(REMOVAL)
STEP 1.
LOOSEN SCREW SECURING FILTER ASSEMBLY MOUNTING CLAMP TO INLET FILTER TUBE AND
LIFT FILTER ASSEMBLY OFF TUBE.
WHEN REPLACEMENT OF INLET FILTER TUBE IS NECESSARY, REMOVE TWO SCREWS AND INLET
STEP 2.
FILTER TUBE.
(INSTALLATION)
STEP 3.
INSTALL INLET FILTER TUBE IN POSITION ON CYLINDER HEAD AND SECURE WITH TWO SCREWS.
STEP 4.
ASSEMBLE AIR INLET FILTER ASSEMBLY ONTO INLET FILTER TUBE. TIGHTEN MOUNTING CLAMP
SCREW.
3-11
