TM 5-4310-375-14
Table 4-1. Service Upon Receipt
REMARKS
ACTION
ITEM
LOCATION
a. Examine screen and panels for
Belt guard
1. Compressor drive
dents, breaks and rust. Repair or
assembly
replace as necessary. (Para 4-14)
b. Check belt tension and adjust if
V-Belts
needed (Fig 2-3). Replace cut, frayed
or stretched belts. Replace belts in
sets. (Para 4-14)
c. Examine drive pulley for tightness
Drive pulley
on motor shaft, damaged keyway,
chipping or cracks in grooves. Replace
a damaged drive pulley. (Para 4-14)
a. Open motor control box door and
Motor control
2. Electric motor
examine starter assembly. When notified
starter assembly
and controls
by operator/crew of defective wiring
or malfunction, repair or replace as
necessary. (Para 4-15)
b. When notified by operator/crew of
Motor assembly
motor malfunction, test motor and
replace when necessary (para 4-16).
Notify Direct Support when you
determine repair is required.
c. Inspect pressure switch and un-
Pressure switch
loader for any wiring damage, dents,
and unloader
and proper cut-in, cut-out operation.
Notify Direct Support for adjustment,
repair, or replacement.
a. When notified by operator/crew of
Cylinder head, first
3. Compressor
cylinder head damage, inspect and replace
stage and second
assembly
as necessary. (Para 4-19)
stage valves.
b. When cylinder head is removed,
inspect first and second stage valves for
wear or damage. Replace the valves as
necessary. (Para 4-19)
c. Clean and examine the intercooler
Intercooler and
and aftercooler for cracks and breaks
aftercooler
replacement when necessary.
d. Inspect flywheel for chipping and
Flywheel
cracks in drive belt grooves and air
circulating blades. Replace a damaged
flywheel. (Para 4-21)
4-2
