TM 5-4310-377-13
3-14. DRIVE BELTS.
This task covers:
a. Removal
b. Cleaning
c. Inspection
d. Replace
e. Installation
SET-UP:
Tools:
1/2 inch wrench
Materials:
Brush, Medium Bristle (Appendix E, item 4)
Cloth, Lint-Free (Appendix E, item 3)
Solvent, Dry Cleaning (Appendix E, item 2)
WARNING
Cleaning Solvent, Federal Specification P-D-680, is toxic and flammable. Use
solvent only in a well ventilated area. Avoid prolonged breathing of fumes. Keep
solvent away from flames. Do not use in excessive amounts. Avoid skin contact.
Personnel:
1 Person
Equipment Conditions:
Electrical power removed at master control panel.
Tank drain cock open and air bleed off (para. 2-2).
Guard assembly removed (para. 3-13a).
Figure 3-13. Drive Belts, Removal.
(1) Loosen four nuts (1) on motor holddown bolts.
(2) Slide motor (2) until belts (3) are loose.
(3) Remove belts (3).
GO TO NEXT PAGE
3-32
