TM 5-4310-378-14
(13) Remove oil sight gage (27) and oil sight gage seal (28).
( 1 4 ) Remove oil drain plug (29) from crankcase (30).
( 1 5 ) Remove all buildup of dirt, grease, etc., by wiping with a clean rag (Appendix E,
item 3).
Dry Cleaning Solvent
(Stoddard Solvent)
P-D-680
C o m b u s t i b l e - do not use near open flames, near welding areas, or
o n hot surfaces.
P r o l o n g e d or repeated contact of skin with liquid can cause
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
t h r o a t and can cause dizziness.
I f any liquid contacts skin or eyes, immediately flush affected area
thoroughly with water. Remove solvent-saturated clothing. If
v a p o r s cause dizziness, go to fresh air.
W h e n handling liquid or when applying it in an air-exhausted,
partially covered tank, wear approved gloves.
W h e n handling liquid or when applying it at an unexhausted,
uncovered tank or workbench, wear approved respirator, goggles,
a n d gloves.
( 1 6 ) Clean using a clean, soft cloth (Appendix E, item 3) or a medium bristle brush
(17) Inspect
(a) for missing or damaged hardware.
(b) cylinders for damage and wear.
( c ) piston and connecting rod assembly f o r damage and wear.
(d) crankshaft for damage and wear.
(e) crankcase for damage.
(f) front bearing cover for damage.
(g) rear bearing cover for damage.
(h) both bearings for damage and wear.
( 1 8 ) Repair of the air compressor (except for the piston and connecting rod assemblies) is
l i m i t e d to the replacement of defective parts.
5-5
