TM 5-4310-379-14
3-34. Wiring Harness (Cont).
b.
Replace. (figure 3-44)
(1) Loosen nut (1) and remove negative cable (2) and black wire (3).
(2) Tag and remove wiring harness (4) from control panel (5), starter (6), alternator (7), and oil pressure sender (8).
(3) Inspect wiring on back of control panel (5). Refer to Appendix F for procedures to manufacture control panel
wiring.
(4) Install wiring harness (4) as tagged to oil pressure sender (8), alternator (7), starter (6) and control panel (5).
(5) Install black wire (3) and negative cable (2) and tighten nut (1).
3-106
