Oil Cooler Assembly.

Figure 4-15. Oil Cooler Assembly, Repair.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
250

TM 5-4310-379-14 4-17. Oil Cooler Assembly. This task covers: a. Repair INITIAL SETUP: Tools Materials/Parts (Cont) General Mechanic's Tool Kit (NSN 5180-00-177-7033) Gasket, Element-to-Housing Wrench, Torque (NSN 5120-00-554-7292) Gasket, Housing-to-Block 2 Studs (7/16-14 x 2-3/4") Materials/Parts Equipment Condition Oil Cooler Gasket, Cover-to Core Water pump removed (para. 3-23). Repair. (figure 4-15) (1) Remove two bolts (1) and lockwashers (2). (2) Install two studs 7/16-14 x 2-3/4 in. in bolt holes. (3) Remove four bolts (3) and lockwashers (4). (4) Remove two bolts (5) and lockwashers (6) and remove oil cooler cover (7), gasket (8), cooler (9) and gasket (10). (5) Remove bolt (11) and lockwasher (12) and remove spacer (13) and move bracket (14) out of way. (6) Remove two bolts (15) and lockwashers (16) and remove housing (17) and gasket (18). (7) Ensure all gasket surfaces are clean and old gasket material removed. (8) Install gasket (18) and housing (17) and install only finger tight two bolts (15) and lockwashers (16) in lower outside bolt holes. (9) Install gasket (10), and oil cooler (9). Ensure all bolt holes and oil passage holes are alined. (10) Install gasket (8) and oil cooler cover (7) and install finger tight four bolts (3) and lockwashers (4). (11) Remove two studs and install two bolts (1) and lockwashers (2), finger tight (12) Install two bolts (5) and lockwashers (6). NOTE Tighten oil cooler attaching bolts gradually and uniformly to ensure a good seal. 4-38

Privacy Statement
Press Release
Contact