Flywheel Assembly.

Figure 4-16. Oil Cooler By-Pass Valve, Replace

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
254

TM 5-4310-379-14 4-19. Flywheel Assembly. This task covers: a. Replace b. Repair INITIAL SETUP: Tools Materials/Parts General Mechanic's Tool Kit (NSN 5180-0-177-7033) Temperature Indicating Compound (Item 26, Wrench, Torque (NSN 5120 00-247-2540) Appendix D) Flywheel Lifting Tool (PN J 6361-01) Flywheel Assembly Torch Outfit, Cutting and Welding Qxy Acetylene (NSN 3433-0-026-4718) Equipment Condition Drive belts removed (para. 3-12). a. Removal. (figure4-17) (1) Connect suitable lifting device to power take-off (1). (2) Remove 12 screws (2) and lockwashers (3) and remove power take-off (1). (3) Remove eight screws (4) and lockwashers (5) and remove drive ring (6). NOTE Crankshaft of engine must be prevented from turning prior to removing screw (7). (4) Remove six screws (7) and scuff plate (8). (5) Connect flywheel lifting tool to flywheel assembly (9) using two 7/16--14bolts of suitable length. WARNING Flywheel assembly is very heavy. Failure to use correct tools may result in injury to personnel. (6) Connect suitable lifting device to flywheel lifting tool to support flywheel. (7) Move upper end of flywheel lifting tool in and out to loosen the flywheel assembly (9) and remove flywheel assembly (9) from flywheel housing (10). (8) Remove flywheel assembly (9) from flywheel lifting tool. 4-42 Change 1

Privacy Statement
Press Release
Contact