TM 5-4310-379-14
5-14. Starter.
This task covers:
Repair
INITIAL SETUP:
Tools
Equipment Condition
General Mechanic's Tool Kit
(NSN 5180-00-177-7033)
Starter removed (para. 3-31).
Pliers, Retaining Ring Set
(NSN 5120-00-789-0492)
Repair.
(1)
Disassemble. (figure 5-13)
(a)
Remove two nuts (1) and remove connector (2).
(b)
Loosen nut (3) and remove lead (4).
(c)
Remove four screws (5) and bracket (6) and remove solenoid (7).
(d)
Remove plug (8) and gasket (9).
(e)
Remove nut (10) and remove plunger (11), washer (12), boot (13), retainer (14), spring (15), retainer
(16), and snap ring (17) as an assembly.
(f)
Remove snap ring (17), and remove retainer (16), spring (15), retainer (14), boot (13), and washer
(12) from plunger (11).
(g)
Mark housing drive (18), lever housing (19), and body (20).
(h)
Remove five long screws (21) and one short screw (22) and remove housing drive (18) and gasket
(23).
(i)
Remove five screws (24) and lockwasher (25) and remove housing (19) and O-ring (26).
(j)
Remove snap ring (27), pin (28), two 0-rings (29), lever (30), driver assembly (31), and drive washer
(32).
(k)
Remove washer (33).
(I)
Remove armature (34) and washer (35) from body (20).
(m)
Remove four screws (36) and lockwashers (37) and remove cover (38) and 0-ring (39).
(n)
Remove pin (40) securing brushes (41) and remove brush spring (42).
(o)
Remove pin (43) securing brushes (44) and remove brush spring (45).
Change 1 5-42
