TM 5-4310-380-13
3-14 DRIVE BELTS- Continued.
a. Removal Continued.
(1)
Loosen four nuts (1) on motor holddown bolts.
(2)
Loosen take-up bolt (2).
(3)
Slide motor (3) until belts (4) are loose.
(3)
Remove belts (4).
b. Cleaning.
(1) Wash the belts in a mild solution of soap (Appendix E, item 5).
(2) Rinse thoroughly with clean water.
(3) Allow to dry.
c. Inspection.
Inspect the belts for damage.
d. Installation.
(Refer to Figure 3-14). Install belts (4) into position.
Figure 3-14. Drive Belts, Installation.
e. Adjustment.
(1) Move motor (3) until the belt deflection at the mid-point between the pulleys is 3/8 to 1/2 inch. Adjust with
take-up bolt (2).
(2) Tighten the motor holddown bolts (1).
END OF TASK
3-27
