Table 2-1. Operator's Preventive Maintenance Checks and Services

SECTION II. OPERATOR'S PREVENTIVE MAINTENANCE

Operator's Preventive Maintenance Checks and Services (Continued) - TM-5-4310-385-13_19

TM-5-4310-385-13 Compressor Reciprocating Air: Electric Motor Driven Caster Mounted 5 CFM 175 PSI C & H Model 20-917 Manual
Page Navigation
12

B - Before Operation D - During Operation A - After Operation W - Weekly Item No. Interval Item To Be Inspected. Procedure: Equipment Not Ready/Available If: B D A W TM 5-4310-385-13 Table 2-1. Operator's Preventive Maintenance Checks and Services 1 COMPRESSOR DRIVE SYSTEM a. Inspect belt guard mounting screws (1). Belt guard is damaged or loose enough to b. Inspect belt guard mounting bolts (2) to tank. obstruct motion of pulley, flywheel or belts. c. Inspect belt guard (3) for damage. 2 COMPRESSOR UNIT WARNING Drycleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property. Avoid repeated and prolonged skin contact by wearing rubber or non-porous gloves when handling the solvent or material wet with drycleaning solvent. Wash hands immediately after exposure with soap and water and use a lanolin based skin cream to prevent skin drying. Do not use near open flame or excessive heat. Flash point of solvent is 100° F (38° C). Do not work with solvent in a closed room. Be sure there is good ventilation or the solvent vapors will build up in the air and become a poisonous mixture which can cause physical injury or even death. 2-3

Privacy Statement
Press Release
Contact