TM 5-4310-386-14
2-7. Reporting Deficiencies. If your equipment does not perform as required, refer to Chapter 3 under Troubleshooting
for possible problems. Report any malfunctions or failures on DA Form 2404, or refer to DA Pam 738-750.
2-8. Equipment is Not Ready/Available If Column. This column lists conditions that make the equipment unavailable
for use because it is unable to perform its mission, or because it would represent a safety hazard. Do not accept or
operate equipment with a condition in the "Equipment is Not Ready If" column.
NOTE
The terms ready/available and mission capable refer to the same status: Equipment is on hand and
is able to perform its combat mission. Refer to DA Pam 738-750.
2-9. Special Instructions. Preventive maintenance is not limited to performing the checks and services listed in the
PMCS table
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive
heat. Flash point of solvent is 138°F (60°C).
a. Keep it Clean. Dirt, grease, oil, and debris get in the way and may cover up a serious problem. Clean as you work
and as needed. Use dry cleaning solvent on all metal surfaces. Use soap and water to clean rubber or plastic material.
b. Bolts. Nuts. and Screws. Check them all for obvious looseness, missing, bent, or broken condition. You can't try
them all with a tool, but look for chipped paint, bare metal, or rust around boltheads. If you find one you think is loose,
tighten it, or report it to unit maintenance if you can't tighten it.
c. Electrical Wires and Cables Connectors. Look for bare wires, and loose or broken connectors. Report defects to unit
maintenance.
d. Fluid Lines. Look for wear, damage, and leaks. Make sure clamps and fittings are tight. Wet spots and stains around
a fitting or connector can mean a leak. If a leak comes from a loose connector, tighten it. If something is broken or worn
out, report it to unit maintenance.
e. Leakage Definitions. It is necessary for you to know how fluid leakage affects the status of your equipment. The
following are definitions of the types/classes of leakage you need to know to be able to determine the status of your
equipment. Learn and be familiar with them. When in doubt, NOTIFY YOUR SUPERVISOR!
Leakage Definitions:
Class I
Seepage of fluid (as indicated by wetness or discoloration) not great enough to form drops.
Class II
Leakage of fluid great enough to form drops but not enough to cause drops to drip from item
being checked/inspected.
2-6
