TM-5-4310-389-14
7.
Note reading of dial indicator. Indicator will show amount of end play between drive shaft and housing.
8.
Lower power take-off until end of drive shaft again rests on wood block and weight of power take-off is no
longer supported by hoist.
9.
Lightly tap on inner side of power take-off housing alternately around bearing retainer to ensure that inner
roller bearing is set against bearing cup. The dial indicator should again be at zero.
10.
Readjust end play, if necessary, by turning bearing retainer clockwise to decrease or counterclockwise to
increase drive shaft end play.
11.
Repeat steps 5 through 9 to ensure shaft end play readings are correct.
12.
Reinstall bearing retainer lock and bolt.
13.
Remove shim stock and dial indicator.
14.
Support power take-off on wood blocks in horizontal position.
NOTE
Rotate the clutch drive shaft when filling bearing cavity to ensure that bearings and housing are full of
grease.
15.
Fill bearing cavity with lithium-based #2 grease, until grease starts to seep out around the clutch shaft at
each end of power take-off housing.
f.
Install Clutch.
1.
Reinstall drive plate with clutch gear ring installed on the drive plate.
2.
Torque to 18 lb-ft.
3.
Reinstall clutch assembly with clutch lever engaged. Torque bolts to 32 lb-ft.
4.
Check belt alignment.
5.
Adjust belt tension (paragraph 3-16).
6.
Adjust clutch lever tension (paragraph 3-39).
4-107
