TM-5-4310-389-14
3.
Place pressure plate (48) on top of the clutch body (smooth face down) with notches in pressure plate in
line with the release lever bosses of the clutch body, then lower pressure plate down on the three pressure
plate separator springs (52).
4.
Lubricate threads on clutch adjusting ring (43) and turn it clockwise into pressure plate (48) until it bottoms.
5
Install clutch release levers (27) in opening of bosses or clutch body (53) with notch end of lever up and
out.
WARNING
To prevent serious eye injury while removing/installing retaining ring(s), wear safety eye protection.
Ensure retaining ring(s) is secure in ring groove.
CAUTION
Ensure retaining rings are securely locked on pins.
CAUTION
Determine the direction the clutch will rotate when attached to the engine, then install lever pins with
the heads of the pins leading the rotation of the clutch.
6.
Align holes in levers (27) with holes in bosses of outer plate, then insert pins (54) through pin holes and
secure with retaining rings (55).
7.
Heeding the match marks previously placed on the two halves, lubricate inside diameter of clutch release
sleeve collar (23). Place two halves together over the shoulder on release sleeve (24) with machined side
of collar down and secure them together with two bolts and nuts. Rotate collar on sleeve to check for free
turning. If collar binds on sleeve, it may be necessary to shim between the collar halves to allow running
clearance.
CAUTION
Ensure the tapped hole in the release sleeve is facing the grease tube when assembled in the power
take-off.
4-103
