TM-5-4310-389-14
3.
Remove two bolts holding flange in place.
4.
Remove the spring, fuel metering valve, and copper washer.
5.
Remove the barrel by pushing from other side (figure 5-87).
6.
Inspect for damaged parts. Replace as required.
c.
Reinstall Plunger and Barrel.
1.
Copper washer in housing. Install barrel and turn until barrel rests 1/4-inch below surface.
2.
Install second copper washer on copper barrel (figure 5-88).
3.
Install delivery valve and spring.
4.
Install delivery valve holder, finger-tighten.
5.
Preassemble and support plate.
6.
Install plunger into barrel, ensuring that the metering sleeve notch engages the control lever pin.
7.
Place timing shims on spring keeper. Place roller assembly on top of timing shims and install roller body,
ensuring that the oil hole is facing up.
Figure 5-87. Copper Washer and Barrel
Figure 5-88. Barrel Assembly
(Flange Removed)
5-58
