TM 5 4310-451-14
4-40. ENGINE CONTROL ASSEMBLY MAINTENANCE.
This Task Covers:
a. Removal
d.
Assembly
b. Disassembly
e.
Installation
c. Cleaning and Inspection
Initial Setup:
Equipment Conditions::
Materials/Parts:
•
Master battery switch in OFF position.
•
Dry cleaning solvent (Item 38, Appendix E)
Tools/Test Equipment:
Marker tags (Item 40, Appendix E)
Tools/Test Equlpment:
•
One cotter pin
•
General mechanic's tool kit
•
Twelve lockwashers
General Safety Instructions:
•
Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
•
Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).
a.
REMOVALI
1. Tag and remove two lines (7) from engine control assembly (8).
2. Remove two nuts (5), lockwashers (4), and compressor control rod (2) from inlet valve (1) and connecting link (3).
Discard lockwashers.
3. Remove two nuts (12), lockwashers (11), and engine control rod (9) from connecting link (3) and governor lever
(10). Discard lockwashers.
4. Remove three nuts (13), lockwashers (14), screws (6), and engine control assembly (8) from bracket (15).
Discard lockwashers.
4-64
