TM 5-4310-451-14
5-61. BLOWER ACCESSORY DRIVE HUB REPLACEMENT (Con’t).
6.
Remove three screws (19), lockwashers (20),
and drive hub (18) with two plates (17) as an
assembly from rear housing (14). Discard
lockwashers.
7.
Remove three screws (15), lockwashers (16),
and two plates (17) from drive hub (18). Discard
lockwashers.
b. CLEANING AND INSPECTION
WARNING
•
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective goggles and gloves,
and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT
breathe vapors. DO NOT use near open flame or excessive heat. The solvent's flash point Is 100°F-
138°F (38°C-590C). If you become dizzy while using cleaning solvent, Immediately get fresh air and
medical help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
•
Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never exceed
30 psi (207 kPa). Wear protective clothing (goggles/shield, gloves, etc.) and use caution to avoid
Injury to personnel.
1. Clean metal parts with dry cleaning solvent and dry with compressed air.
2. Inspect splines In bore of drive hub. If defective, replace drive hub.
3. Inspect plates and washers for breaks, cracks, dents, and distortion. Replace if defective.
4. Inspect drive hub bosses for stripped threads.
TA705075
5-204
