TM 5-4310-451-14
5-61. BLOWER ACCESSORY DRIVE HUB REPLACEMENT.
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Master battery switch in OFF position.
•
Dry cleaning solvent (Item 38, Appendix E)
•
Engine cool.
•
Marker tags (Item 40, Appendix E)
•
One copper washer
Tools/Test Equipment:
•
One Copper washer
•
Two gaskets
•
General mechanic's tool kit* Eleven lockwashers
•
Field automotive shop set
General Safety Instructions:
•
Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
•
Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).
a.
REMOVAL
NOTE
Tag screws when removing to assist In Installation.
1.
Remove nut (5), copper washer (4), and screw (1). Discard copper washer.
2.
Remove three screws (9) and lockwashers (8). Discard lockwashers.
3.
Remove two screws (7), lockwashers (6), cover (2), and gasket (3). Discard lockwashers and gasket.
4.
Remove retaining ring (10) from drive adapter (11).
TA705073
5-202
