TM 5-4310-451-14
5-74.
ENGINE STARTER TESTING.
This Task Covers:
a. Continuity Test
c. Lock Torque Test
b. No Load Test
Initial Setup:
Equipment Conditions:
Materials/Parts:
Engine starter removed (see paragraph 4-53).
Rags (Item 35, Appendix E)
Tools/Test Equipment:
Dry cleaning solvent (Item 38, Appendix E)
Automotive fuel and electrical system shop set
Two gaskets
Alternator and starter automotive generator
test stand
General Safety Instructions:
Dry cleaning solvent is flammable and must not be used near open flame. Use only In a well-ventilated area.
a.
CONTINUITY TEST
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles and
gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO
NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvents flash point Is
100°F-138°F (380C-590C). If you become dizzy while using cleaning solvent, Immediately get fresh
air and medical help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
1.
Clean outside of engine starter (1) with dry
cleaning solvent and clean rag.
2.
Check that pinion (2) will rotate In one direction
and slip in other direction. If not, repair engine
starter (see paragraph 575).
TA705169
5-303