TM 5-4310-451-14
5-75.
ENGINE STARTER REPAIR (Con’t).
6.
Check length of brushes. If length is less than 0.5 in. (12.7 mm), replace brushes.
7.
Inspect brush springs for distortion.
8.
Inspect splines and gear teeth on starter drive for damage.
9.
Check bushings for damage and wear. If inside diameter of bushings is more than 0.005 in. (0.127 mm) larger
than armature shaft diameter, replace bushings.
10.
Replace unserviceable parts.
c.
ASSEMBLY
1.
Install insulator bushing (86) and plate (85) on terminal stud (78).
2.
Install plate insulator (84) and field coil (87) on field frame (5).
3.
Install four pole shoes (82) on field frame (5) with eight screws (83).
4.
Install insulator (81), washer (80), and nut (79) on terminal stud (78).
5.
Position disc insulator (76), connector plate (77), and two support plates (75) on plate assembly (69).
TA705183
5-317
