TM 5-4310-451-14
Section VII. BRAKEDRUM AND TIRE MAINTENANCE
Paragraph
Page
Number
Paragraph Title
Number
5-78
Brakedrum Repair ........................................................................................
5-333
5-79
Tire Repair ....................................................................................................
5-335
5-78. BRAKEDRUM REPAIR.
This Task Covers:
a.
Inspection
b.
Repair
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
Hub and brakedrum removed (see paragraph 4-69).
Field automotive shop set
General Safety Instructions:
DO NOT use a dry brush or compressed air to clean brake assembly or brake components.
Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
a. INSPECTION
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless
area has been properly cleaned. There may be asbestos dust on these
components which can be dangerous If you touch It or breathe It. Wear an
approved filter mask and gloves. Never use compressed air or a dry brush to
clean brake components. Dust may be removed using an Industrial-type
vacuum cleaner. Clean dust or mud away from brake components with water
and a wet, soft brush or cloth. Failure to follow this warning may result In
serious Illness or death to personnel.
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat. The solvent's flash point is 100°F-138°F (38°C-59°C).
If you become dizzy while using cleaning solvent, Immediately get fresh air and
medical help. If solvent contacts eyes, immediately wash your eyes and get
medical aid.
1.
Clean all parts with dry cleaning solvent. Allow to dry.
5-333