TM 5-4310-452-14
4-47. SAFETY CIRCUIT BYPASS SWITCH REPLACEMENT.
This Task Covers:
a. Inspection
c. Installation
b. Removal
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
• Engine off.
• General mechanic's tool kit
• Battery cables disconnected (see paragraph
• Multimeter
4-57).
• Left door assembly open.
a.
INSPECTION
1.
Remove 2 electrical leads (2) from switch terminals
(3). Visually inspect switch (4) for damage or
broken switch terminals.
2.
Using multimeter, test switch (4) for continuity and
function. Replace switch if damaged or defective.
b.
REMOVAL
1.
Remove boot (6) and nut (5) from switch (4).
Remove switch from control panel (1).
c.
INSTALLATION
1.
Position switch (4) in place in control panel (1). Install nut (5) and boot (6) on switch.
2.
Install 2 electrical leads (2) on switch terminals (3).
FOLLOW-ON TASKS:
• Connect battery cables (see paragraph 4-57).
• Close left door assembly.
TA505477
4-91
