TM 5-4310-452-14
4-50. COMPRESSOR OIL TEMPERATURE GAGE AND FUEL LEVEL GAGE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
• Engine off.
• General mechanic's tool kit
• Left door assembly open.
• Battery cables disconnected (see paragraph
4-57).
NOTE
Use this task to replace compressor oil temperature gage or fuel level gage, Compressor oil
temperature gage is shown.
a.
REMOVAL
1.
Remove window (see paragraph 4-55).
2.
Remove 3 electrical leads (5) from compressor oil temperature gage (1).
3.
Unscrew 2 knurled nuts (4) from compressor oil temperature gage (1).
4.
Remove retainer (3) and compressor oil temperature gage (1) from indicator panel (2).
b.
INSTALLATION
1.
Position compressor oil temperature gage (1) in place in indicator panel (2).
2.
Install retainer (3) and 2 knurled nuts (4) on compressor oil temperature gage (1).
3.
Install 3 electrical leads (5) on compressor oil temperature gage (1).
4.
Install window (see paragraph 4-55).
FOLLOW-ON TASKS:
• Connect battery cables (see paragraph 4-57).
• Close left door assembly
TA505481
4-96
