TM 5-4310-452-14
4-55. INDICATOR PANEL ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
• Engine off,
• General mechanic's tool kit
• Battery cables disconnected (see paragraph
4-57).
• Left door assembly open.
a.
REMOVAL
1.
Disconnect 2 wire leads (6) from lamp assembly (3).
Remove nut (5) and starwasher (4) from lamp
assembly.
2.
Remove lamp assembly (3) from compressor unit.
3.
Remove hood (1) and bulb (2) from lamp assembly
(3). Discard bulb if necessary.
4.
Unscrew 8 screws (12) and remove window (11).
5.
Remove compressor oil temperature gage and fuel
level gage (see paragraph 4-50).
6.
Remove discharge pressure gage and fuel pressure
gage (see paragraph 4-51).
7.
Remove tach/hourmeter (see paragraph 4-52).
8.
Remove ammeter (see paragraph 4-53).
9.
Remove engine oil pressure gage (see paragraph 4-
54).
10. Remove oil pressure switch (see paragraph 4-41).
11. Push in on indicator panel assembly (13) and
remove from housing.
12. Remove 4 screws (10) and nuts (7) from gage panel
(9) and frame (8).
13. Remove gage panel (9) from frame (8).
4-101
