TM 5-4310-452-14
4-80. TOOL BOX PAD REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Engine off.
• Tool box pad (as required)
Tools/Test Equipment:
• Plastic clips (as requir ed)
• General mechanic's tool kit
a. REMOVAL
NOTE
Use this task to remove any 1 of 4 tool box pads, Right rear tool box pad is shown.
1. Release 2 clamping catches (5) on tool box (4) and
open tool box lid (1).
2. Remove plastic clips (2) and tool box pad (3) from
tool box (4). Discard tool box pad and plastic clips.
b. INSTALLATION
1. Install new tool box pad (3) and plastic clips (2) in
tool box (4),
2.
Close tool box lid (1) and latch 2 clamping catches
(5).
4-160
