TM 5-4310-452-14
4-81. DATA PLATES, DECALS, AND INSTRUCTION HOLDERS REPLACEMENT.
This Task Covers:
a. Removal of Data Plates and Instruction Holders
c. Removal of Warranty Decal
b. Installation of Data Plates and Instruction
d. Installation of Warranty Decal Holders
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Engine off.
• Drive screws (as required)
Tools/Test Equipment:
• Rivets (as required)
• General mechanic's tool kit
• Electric drill
• Rivet gun
• Twist drill bit
a. REMOVAL OF DATA PLATES AND INSTRUCTION
HOLDERS
NOTE
Use this task to remove any 1 of 13
data plates and instruction holders.
Trailer operating instructions data
plate is shown.
1.
Using electric drill and twist drill bit, remove rivets or
drive screws (1) holding data plate (2) in place on
compressor unit.
2.
Remove data plate (2).
b.
INSTALLATION
OF
DATA
PLATES
AND
INSTRUCTION HOLDERS
1.
Position data plate (2) in place on compressor unit.
2.
Install rivets or drive screws (1) as required to hold
data plate in place.
4-161
