TM 5-4310-452-14
5-37. OIL COOLER REPLACEMENT (Con't).
5.
Remove plug (6) and preformed packing (7) from oil cooler (2). Discard preformed packing.
NOTE
Clean oil cooler and rear wall baffle of rubber strips.
6.
Remove 2 rubber strips (9). Discard rubber strips.
b. INSTALLATION
1.
Position 2 new rubber strips (9) in place on rear wall baffle (4).
2.
Install new preformed packing (7) on plug (6). Install plug in oil cooler (2).
3.
Aline mounting holes of oil cooler (2) with holes in rear wall baffle (4) and install 8 screws (11) and nuts (8).
4.
Install 8 screws (5) and nuts (1).
5.
Aline mounting holes in fan shroud (12) with mounting holes in oil cooler (2) and install 8 screws (13), nuts (3),
and 4 screws (10).
FOLLOW-ON TASKS:
• Install front end panel assembly (see paragraph 4-82).
• Install oil temperature bypass valve (see paragraph 5-36).
• Install compressor oil lines and fittings (see paragraph 4-86).
• Install compressor fan and fan drive (see paragraph 4-92).
TA505612
5-92
