TM 5-4310-452-14
4-1. PREPARATION FOR USE (Con't).
(4)
Raise unit off carrier with lifting device and set unit down on flat, level surface.
c.
Inspection of the Unit.
(1)
Check carefully for and report any and all damage.
(2)
Refer to the bill of lading and ensure that the unit has everything listed.
(3)
Check tires for proper inflation (see Table 2-1).
4-2. LUBRICATION.
CAUTION
The unit is shipped from the manufacturer fully lubricated and with the engine and compressor
sumps filled to the proper levels with the correct grades of oils. If a lubrication point was
overlooked by the manufacturer, now is the time to find it, not when the unit is being
operationally tested.
Check all points of lubrication (see LO 5-4310-452-12).
4-3. SERVICING INSTRUCTIONS.
a.
Start the unit and let run for a period no less than 20 minutes and no more than 45 minutes (see paragraph 2-12).
b.
Perform "During Operation" checks (see paragraph 2-14), and observe the following:
(1)
All controls and indicators are in normal range.
(2)
There are no air or oil leaks present.
(3)
The unit shows no unusual tendencies, for example: engine stalling repeatedly, excessive vibration, or
other signs of improper operation.
4-2
