TM 5-4310-452-14
3-6. FUEL/WATER SEPARATOR SERVICING.
NOTE
Drain fuel/water separator only when water Is visible in sightbowl.
a.
Open left door assembly (1).
b.
Place suitable container under trailer at bottom end of hose (6).
c.
Loosen drain assembly knob (5) and drain water
from fuel/water separator (3) until only clear fuel is
draining.
d.
Tighten drain assembly knob (5) and unscrew
hand primer pump knob (2).
e.
Using hand primer pump knob (2), pump until
pressure is felt and sightbowl (4) is full of fuel.
f.
Tighten primer pump knob (2).
g.
Start engine and check for leaks (see paragraph
2-1 2).
h.
Shut engine off (see paragraph 2-13).
i.
Close left door assembly (1).
3-7. COMPRESSOR OIL COOLER CLEANING.
a.
Open right access door (2).
b.
Open left and right door assemblies (1).
WARNING
Compressed air used for cleaning or
drying purposes, or for clearing
restrictions, should never exceed 30
psi (207 kPa). Wear protective
clothing
(goggles/shield,
gloves,
etc.) and use caution to avoid Injury
to personnel.
c.
Using compressed air, clear dust and dirt from
oil cooler (3).
d.
Close left and right door assemblies (1).
e.
Close right access door (2).
3-9