b. Cleaning and Inspection.
c. Installation. Installation is the reverse of
(1) Remove any dents in the toolbox and
removal. Refer to figure 3-6.
filler housing. Check that the toolbox door
closes easily and that the filler housing fits
within the enclosure snugly.
Housing
(2) Check the bulb in the trouble light and
a. Removal. The toolbox (8) can be removed
replace if defective (para 3-20). Pull out the
as shown in figure 3-6. Tag and disconnect
reel and then let it rewind. If the reel does not
electrical leads and remove the trouble light
operate, replace it.
reel (11) by removing the attaching hardware
c. Installation. Installation is the reverse of
(12 and 13). Remove the fuel filler housing
removal. Refer to figure 3-6 as an aid to instal-
(4) by turning latch (located behind the hous-
lation.
ing inside the enclosure 90 in any direction.
Section VIII. ENGINE ASSEMBLY
control panel from oil pressure transmitter
3-40. General
(44).
The engine assembly is a 4-cylinder, air cooled
(5) Remove the two compressor drive
overhead valve, gasoline operated device. It is
belts (39).
capable of satisfactory operation in temperate,
(6) Remove engine attaching hardware
desert, arctic, and tropical environment when
and remove the engine.
serviced regularly.
b. Installation.
(1) Lower engine assembly (7, fig. 3-6)
over mounting plate holes being certain to aline
a. Removal.
holes in engine bracket mounting base (8).
(1) Remove enclosure as described in
(2) Install attaching hardware and finger
tighten. Final tightening is accomplished after
installation and adjustment of drive belts (39
(2) Disconnect the fuel line, choke control
and 40). Refer to paragraph 3-10 for adjust-
cable and the throttle control cable before re-
ment of drive belts.
moving engine.
(3) Install components to the engine as-
(3) Loosen the four bolts, nuts, and wash-
sembly in the reverse order of removal.
ers attaching the engine (7, fig, 3-7) to the
mounting base (8) on the tank (41).
(4) Tag and disconnect electrical leads to
Refer to TM-2805-203-14 for further infor-
the starter assembly and oil pressure gage on
mation on the engine.
