TM 5-4930-218-14
c. Disassemble the remaining portion of the landing
e. Remove lock screw (27) to free end cap (28). Un-
gear by removing pins (14), axle (15), and wheels (16).
screw end cap and remove bearing cup (29) and cone
You need not remove wheel bushings (17) unless
(30).
replacement is necessary,
f. Drive out pin (31) and remove gear (32) and
d. Remove handle (21) from crank arm (25) by
spacer (33) from end of screw shaft (40) which will
removing nut (18), bolt (19), and washer (20). Remove
now drop out of outer tube assembly (39).
crank arm by removing cap screw (22), lock washer
g. Remove gear (35) and washer (36) from outer
(23), and washer (24).
tube assembly (39). You should not remove pin (34)
