Technical
Service
Inspection
Monthly
Weekly
GENERAL-Continued
........
6
6
See that deficiencies noticed are corrected or
reported to the proper authority.
Modifications. See if all available modifioa-
7
7
........
tion work orders applying to this machine
have been completed and recorded on DA
Form 478 (MWO and Major Unit Assembly
Replacement Record-Organizational Equip-
ment File).
ENGINE AND ACCESSORIES
Cylinder Heads, Manifolds, and Gaskets. In-
1
11
11
spect the cylinder heads, manifolds, and ex-
haust pipe for leaks, loose mounting bolts
and nuts, and defective gaskets.
.......
11
11
Tighten any loose manifold and exhaust pipe
mounting bolts and nuts. Replace any de-
fective gasket. On new or reconditioned
engines, check all cylinder-head bolts for
tightness at the first weekly service. The
correct torque-wrench pull is 90 foot-pounds.
Valve Mechanism. Check the valve adjustment
12
12
12
if excessive valve noise or loss of power is
noticed. The approximate valve-rocker arm
clearance with the engine cold is 0.014 inch
for both valves.
........
12
12
Adjust the valve-rocker arm clearance if neces-
sary. Be sure the valve-cover gasket is in
good condition and that the cover fits se-
curely.
Compression Test. Test the compression of all
13
13
........
cylinders and record the readings on DA
Form 464. Normal compression pressure at
cranking speed is 75 to 80 psi open throttle.
Crankcase, Breather. Inspect the crankcase for
14
14
14
leaks. Check the condition of crankcase
breather and cap.
........
14
14
Correct or report any oil leaks noticed. Change
the oil and clean the breather if necessary.
Refer to the current lubrication order.
Oil Filters. Inspect the oil filter assembly con-
15
15
15
nections for leaks while the engine is running.
44