crankcase and in stall the two taper pins (20). Install the 10 hex head bolts (19) and lockwashers (18). Connect the elbow
(7), tube assembly (8) and connector (11) to the accessory drive housing (6) and tappet chamber in the crankcase. Install
1
Gear cover
13
Bolt, hex hd, 7/16-14 x 2 (4 req)
2
Gear cover bushing
14
Taper pin
3
Accessory drive shaft
15
Lockwasher, 7/16 (4 req)
4
Pipe plug
16
Woodruff key
5
Accessory drive gear
17
Gasket
6
Accessory drive housing
18
Lockwasher, 3/8 (10 req)
7
Elbow, 1/4 x 1 MPT x 90
19
Bolt, hex hd, 3/8-16 x 1/4 (10 req)
8
Tube assembly
20
Taper pin
9
Governor drive gear
21
Oil seal half
10
Taper pin
22
Thrust plug
11
Connector, 1/4 x 1/8 MPT
23
Oil seal
12
Drive housing bushing
Figure 101. Exploded view of gear cover assembly.
the water pump (par. 195), fan, (par. 88b), shutterstat (par. 81b), fan belt (par. 85), fuel pump (par. 75b), tachometer drive
and front half cover (par. 216c), distributor (par. 97b), and governor (par. 110b). Install the engine-compressor (par. 215).
230