TM 9-4310-394-13
4-13.
INFORMATION PLATES AND DECALS REPLACEMENT.
This Task Covers:
a.
Removal
b.
Cleaning
c.
Installation
INITIAL SETUP
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Drill, Hand Portable (Appendix B, Item 2)
Drill Bits (Appendix B, Item 5)
Riveter, Blind, Hand (Appendix B, Item 4)
Material's/Parts Required
Rivets, 97517A015 (Appendix H, Item 1)
Equipment Condition
Air compressor unit shut down and cool.
a.
Removal
(Refer to Figure 4-3).
(1)
Drill out four .125 in. dia. rivets (1) that holds information plate (2) onto unit. Repeat for other
information plates as required.
(2)
Remove information plate (2) from unit.
(3)
Use a scraper to remove decals (3) or (4) from unit.
b.
Cleaning.
Remove all build up of dirt, oil, and debris from all surfaces.
c.
Installation.
(1)
Remove protective backing from new decals (3) or (4) and carefully position and install decals onto unit.
(2)
Place information plate (2) into position on unit and install four rivets (1). Repeat for other information
plates as required.
4-14