TM9-4310-396-13
e.
Remove Knob and Cable Assembly.
(1)
Mark cylinder assembly (4, Figure 4-21) for correct position setting on top of cable bracket (3).
(2)
Remove plain hexagon nuts (1), cap screw (2), and pry cable bracket (3) apart.
(3)
Remove cylinder assembly (4).
(4)
Loosen set screw in cable stop (5) and remove cable stop (5).
(5)
Loosen cap screw (6).
(6)
Remove cap screw (7), bracket (8), and cable bracket (3).
(7)
Remove cable (9).
(8)
Remove plain hexagon nut (10) and slide plain hexagon nut over cable (9) length.
(9)
Remove knob and cable assembly (11) from frame control panel (12).
f.
Remove Speed Control.
NOTE
Engine assembly should be removed (para. 4-16) before removing speed control.
(1)
Remove nonmetallic tube (13) attached to cylinder assembly (4).
(2)
Remove cylinder assembly (4) (para. 4-29, e.).
(3)
Disconnect extension spring (14) from top of bracket (15).
(4)
Remove cap screws (16).
NOTE
Mark the appropriate hole to its applicable spring.
(5)
Remove helical extension springs (17 & 18).
(6)
Remove bracket (19).
(7)
Remove manual control lever (20) and torsion spring (21).
4-57
