TM9-4310-396-13
a. Removal. - continued
NOTE
Insure all fuel is drained into appropriate container.
(9) Remove nonmetallic hose (8) from fuel tank assembly (9).
(10) Remove hexagon nuts (10), lock washers (11), flat washers (12), and cap screws (13) holding engine to sub-
base.
(11) Remove hexagon nuts (14), lock washers (15), and flat washers (16).
(12) Remove diesel engine (17).
b. Installation.
(1) Install diesel engine (17).
(2) Install cap screws (13), flat washers (18 & 12), lock washers (11), and hexagon nuts (10).
(3) Install adjusting bolts (19), flat washers (20 & 16), lock washers (15), and hexagon nuts (14).
(4) Tighten V-belts (reference para. 4-15).
(5) Install nonmetallic hose (8) to fuel tank assembly (9).
(6) Install oil temperature transmitter (reference para. 4-29, i.) and connect wire.
(7) Connect starter wires (reference para. 4-19).
(8) Install cable assembly (reference para. 4-29, e.).
(9) Install cylinder assembly (reference para. 4-29, e.).
(10) Connect wires (7).
(11) Connect wire coupling (5) to current limiter (6).
(12) Connect exhaust discharge hose (4) and pipe union (3). Tighten pipe union.
(13) Tighten set screw (1) of exhaust muffler (2).
4-27
